Shs Tube Weight Calculator

SHS Tube Weight Formula:

\[ Weight = (Side \times 4 - 4T) \times T \times Length \times Density \]

Side (m):

T (m):

Length (m):

Density (kg/m³):

kg/m³

Weight:

Unit Converter ▲

Unit Converter ▼

From:	To:

1. What is the SHS Tube Weight Formula?

The SHS (Square Hollow Section) tube weight formula calculates the weight of square steel tubes based on their dimensions and material density. This is essential for structural engineering, construction, and material estimation.

2. How Does the Calculator Work?

The calculator uses the SHS tube weight formula:

\[ Weight = (Side \times 4 - 4T) \times T \times Length \times Density \]

Where:

\( Side \) — Length of one side of the square tube (meters)
\( T \) — Wall thickness of the tube (meters)
\( Length \) — Length of the tube (meters)
\( Density \) — Material density (kg/m³, typically 7850 kg/m³ for steel)

Explanation: The formula accounts for the cross-sectional area of the tube walls multiplied by length and material density.

3. Importance of Weight Calculation

Details: Accurate weight calculation is crucial for structural design, transportation planning, material cost estimation, and load-bearing capacity assessments.

4. Using the Calculator

Tips: Enter all dimensions in meters. For steel tubes, use 7850 kg/m³ as the density. All values must be positive numbers.

5. Frequently Asked Questions (FAQ)

Q1: What is the typical density for steel tubes?
A: The standard density for carbon steel is approximately 7850 kg/m³.

Q2: How do I convert mm to m for the calculator?
A: Divide mm values by 1000 (e.g., 50mm = 0.050m).

Q3: Can this be used for rectangular tubes?
A: No, this formula is specifically for square tubes. Rectangular tubes require a different formula.

Q4: What about tube corners?
A: This formula assumes sharp corners. For rounded corners, a correction factor may be needed.

Q5: How accurate is this calculation?
A: It provides theoretical weight. Actual weight may vary slightly due to manufacturing tolerances.